Joins two strips, end to end
The HiluX Double SmartClip has a connector at both ends of its 15 cm cable, so it links two lengths of 10 mm COB LED strip directly to each other — no loose lead, no soldering. Use it to carry a run around a corner, across a doorway or over any gap where the strip has to stop and start again, and to rejoin a strip after a cut.
The difference from the standard SmartClip
The standard SmartClip terminates in a bare cable for feeding a strip from a driver or connector. The Double version replaces that bare end with a second clip, so the 15 cm cable becomes a bridge between two strip sections instead of a supply lead.
Clicks into place, no tools
Align each strip end with the contacts and press the clip shut. Both joints are made the same way, in seconds, with nothing to solder and nothing that cannot be opened again.
Built to stay connected
The housing uses the same durable material rated for indoor and outdoor use, so the joint survives cold, damp and awkward corners. Supplied as a 5-pack — enough to handle several corners or gaps in one installation.
