Strip to cable, without soldering
The HiluX SmartClip connects a 10 mm COB LED strip to a 15 cm flying lead. One end clips onto the strip; the other end is a bare cable you take to your driver, a connector or the next section of the run. It is the clip to reach for when a strip has to be fed from somewhere else — at the start of a run, after a cut, or where the strip ends but the power does not.
Clicks into place, no tools
Line the strip up with the contacts and press the clip shut. No soldering, no special tooling, and nothing that has to be undone if you change your mind later. That makes it as workable for a first LED project as it is on a professional install.
Built to stay connected
The housing is made from a durable material rated for indoor and outdoor use, so the joint holds up in a cold garage, a damp bathroom or under a soffit. Supplied as a 5-pack, so there are spares in the box for the cuts you did not plan.
Rearrange whenever you want
Because nothing is permanent, you can shorten, extend or move a strip run later and simply re-clip it. Useful under cabinets, along shelving and in any installation likely to be adjusted after the first fit.
